Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
– Indication of the programme dura-
tion or the remaining time of a run-
ning programme, e.g.
" 1200
time 01:30 ".
If you wish to change the display mode:
• Press both buttons, indicated by the
arrows simultaneously and hold them
for approx. 2 seconds. The display in-
dicates the new display mode:
– " End of wash " or
– " Remaining time displayed ".
Wash programmes
Programme selector
The programme selector can be turned ei-
ther clockwise or counter-clockwise.
3
With the programme selector a pro-
gramme is selected ; however, it will
start only if the »Start/Pause«
ton is pressed.
For detailed information about the individ-
ual wash programmes, refer to the "Pro-
gramme table".
Main programmes
Depending on the type of textile, the fol-
lowing main programmes are available:
• Cottons
• Synthetics
• Delicates
• Wool
Each of these main programmes comprises
a complete washing cycle – wash, rinse
and, where appropriate, spin.
A
Always adjust the programme to suit
the textile type, colour, degree of soil-
ing and the permissible washing tem-
perature.
Always observe the care symbols
shown on the garment labels!
For each main programme different tem-
peratures can be selected.
3
Select the temperature only as high as
absolutely necessary.
A high temperature means high pow-
er consumption.
Special programmes
For specific applications you can select any
of the following special programmes:
• Soft rinse
This programme is also used for
starching.
• Spin/Pump
This programme spins at maximum
speed.
A
For delicate fabrics the spin speed
should be reduced!
You can also use this programme if the
machine has stopped for a rinse hold,
and you want to pump out water (see
Rinsehold
• Quick 30°C
Select this programme if you need to
wash small loads of cotton/blended
fabrics only briefly.
but-
/ Hand wash
).
G
55
Publicité
Chapitres
Table des Matières
