At A Glance; Preparation And Start; Changing The Wash Programme; Aborting A Programme - Brandt WFH 1481 D Guide D'installation Et D'utilisation

AT A GLANCE

Preparation and start

1. Open water tap fully. Check to see
that all hoses are tight.
2. Place laundry in the drum.
3. Fill in detergent and fabric conditioner.
4. Set the programme selector.
5. If desired:
– activate any additional function(s),
– set the spin speed,
– set a preset time.
6. Press the »Start/Pause«
(except when setting a preset time).
The display indicates the settings for
the running programme.

Changing the wash programme

1. Set the programme selector to »Stop«
and wait approx. 2 seconds.
2. Set the programme selector to the
new programme.
3. Press the »Start/Pause«

Aborting a programme

1. Set the programme selector to »Stop«
and wait approx. 2 seconds, then set
the programme selector to »Spin/
Pump .
2. Press the »Start/Pause«
3. Wait for the programme cycle to end.

Adding more laundry

3 This is only possible during the time-
delay period.
1. Open the door and add laundry.
2. Close the door.

Programme halted by rinsehold

3 This condition is indicated by a flash-
ing »Rinsehold« indicator lamp
and " Pause " on the display.
If you wish to spin :
1. Set the spin speed.
2. Press the »Start/Pause«
The programme is continued, pumps
out and spins.
If you wish to pump out only:
1. Set the spin speed to " 0 ".
2. Press the »Start/Pause«

Spinning the laundry again

3
If you wish to spin again:
1. Set the programme selector to »Stop«.
2. Open the door and rearrange the
button
3. Set the programme selector to »Spin/
4. Set the spin speed.
5. Press the »Start/Pause«
After completion of the programme
cycle
3
button.
1. As soon as the »Door locked«
2. Set the programme selector to »Stop«.
3. Close tap.
button.
4. Wipe out the sealing fold of the rub-
5. Leave door and detergent dispensing
6. Clean the suds pump filter approx.
3
button.
The programme is continued, only
pumping the water out.
The automatic spin-correction-system
can prevent spinning in case the drum
is out-of-balance.
laundry evenly in the drum.
Pump .
The programme is finished when the
message " End ...:... " flashes on the
display.
dicator light goes out, open the door
and remove the laundry.
ber collar; check for foreign matter.
drawer open to dry.
every 40 wash cycles , in order for the
automatic suds circulation to work
properly. On the display the message
" Recycling filter needs clean-
ing " is shown.
If the suds pump filter is not cleaned,
there is a risk of the suds pump be-
coming blocked after some time. The
display then shows the message
" Clean pump filter or drain
hose ".
button.
button.
in-
G
59