1. Loosen the locking nuts on the feet
with the open ended spanner.
2. Adjust feet until the appliance is level
and does not rock.
3. Important: Tighten all locking nuts af-
ter the machine has been levelled.
Connecting the water supply
This appliance can be connected to water
tabs with a 3/4" B.S.P. thread.
Important:
• Bear the permissible water pressure
and the max. inlet temperature in
mind (see "Technical specifications").
Install a pressure reducing valve if the
water pressure is higher.
• Do not connect to a water heater (in-
stantaneous water heater or unpressu-
rised boiler), as the water pressure is
insufficient.
• Check with customer service for hose
extensions. Do not use home-made ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Required tool:
None. (Do not use a pipe wrench!)
1. If the inlet hose is not yet installed,
connect the offset end to the appli-
ance's rear panel and tighten "finger-
tight".
2. Connect the other end of the inlet
hose "finger-tight" to the water tap.
3
Depending on model, the water hose
has an integrated "Aquastop" or
"Aquastop PLUS", which turns off the
water supply should a leakage occur.
3. Open the water tap fully and check all
connections for tightness; close water
tap again. Correct the position of seals
and screw couplings, if necessary.
Connecting the drain hose
The drain hose can be hung to a wash-ba-
sin, sink or bathtub – or connected perma-
nently to a siphon trap.
Important:
• Do not run the drain hose higher than
100 cm above floor level for the suds
pump to be able to pump out.
• The water must be able to run off un-
hindered. Washbasins with a small
drain are not suitable.
• The end of the hose must not im-
merge in the pumped-out water.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Fastening the hose holder:
1. Pull the hose holder supplied over the
end of the drain hose.
Aquastop /
Aquastop PLUS
49
G