Brandt WFH 1481 D Guide D'installation Et D'utilisation page 67

3. Fold down the run-off flap and place a
low bowl underneath.
4. Turn the suds pump filter counter-
clockwise by approx. 1/4 turn and let
the water run off into a bowl. Empty
bowl and repeat as often as necessary.
A
With a fully loaded drum (e.g. at a
power failure) up to 20 litres of water
may need to be drained!
5. If there is no more water emerging, re-
move the suds pump filter.
6. Clean the suds pump filter and suds
pump opening. Check to see if the
pump's impeller turns freely.
7. Replace the suds pump filter and
tighten it (turn clockwise). Close run-
off flap and service door.
Water inlet filters
Clean if water flows very slowly, or not at
all.
1. Switch appliance off, close the water
tap.
2. Take the inlet hose off.
3. With a pair of combination or pointed
pliers remove the strainer in the
"Aquastop" resp. "Aquastop PLUS" (ac-
cording to model), clean and put it
back in place.
4. Except for "Aquastop PLUS": With a
pair of combination or pointed pliers
remove the strainer from the inlet port
at the rear, clean and put it back in
place.
5. Put inlet hose back on and tighten
"finger-tight".
6. Open the water tap fully and check all
connections for tightness.
Decalcifying
If the detergent is proportioned correctly,
it is not necessary to decalcify the appli-
ance.
• If necessary, use only a decalcifying
agent suitable for washing machines.
Observe the information given on the
packing!
Strainer
Strainer
G
65