Siebert S202 Série Manuel D'utilisation page 39

Reduction of display brightness
The brightness of the display can be reduced with the following command:
Normal brightness: $L0
Reduced brightness: $L1
ESC sequences
The character <ESC> (1B
e.g. <ESC>L1 instead of $L1.
Power-on reset
After the operating voltage is applied, minus signs appear in all decades in order to
signal operational readiness of the unit. If a display test has been preselected in the
menu, it runs beforehand.
Character set
In addition to the numbers 0...9, the character set also contains the other characters
that can be displayed with a 7-segment matrix. They are reproduced in the table
below with the corresponding hex code.
20/2B 2D 30
- 0
41/61 42/62 43
A b C
59/79 5F 63
Y _ c
BAL S202 SER M 1.0
) can be used in the command instead of the $ character,
h
31 32 33
1 2 3
44/64 45/65 46/66 47/67
d E F
68 69 4E/6E 4F/6F 52/72 54/74
h i n
34 35 36
4 5 6
48 49 4A/6A 4C/6C 50/70
'
G H
o r t
37 38 39
7 8 9
J L P
75 58/78 other
u € w
2C/2E
.
55
U
39