Manual Time Setting; Alarm Setting - TFA 35.1089.IT Livret D'instructions

Time Reception OFF function is activated. The Time Reception icon and the
DCF icon will not be displayed on the LCD.

MANUAL TIME SETTING

In case the weather station is not able to detect the radio-controlled time (DCF
time) signal (disturbances, transmitting distance, etc.), the time can be
manually set. The clock will then work as a normal Quartz clock.
Hours (flashing)
To set the clock:
1. The hour digits start flashing in the time display section.
2. Use the + key to adjust the hours and then press SET key to go to the
minute setting.
3. The minute will be flashing. Press the + key to just the minutes.
4.
Confirm with the SET key and exit the setting mode.
Note :
The unit will still try to receive the signal despite a manual setting. When the
signal is received, the manually set time will automatically be replaced by the
received time. During reception attempts, the DCF tower icon will flash. If
reception has been unsuccessful, the DCF tower icon will not appear but
reception will still be attempted.

ALARM SETTING

Alarm icon (ON)
To set alarm:
1. Press and hold ALARM for about 3 seconds until the alarm time display
flashes.
2. The hour digit and the alarm icon will be flashing. Press the + key to
adjust the hour.
Minutes (flashing)
27
Alarm time