Zeiss Stemi 305 Mode D'emploi page 20

ZEISS
Fig. 10 Installing the stereo microscope
Fig. 11 Setting the ease of motion of the
focusing drive
18
INSTALLATION
Installing the stereo microscope
•
Insert the connection cable (Fig. 10/3) supplied
with the device into the socket on the Stemi
body and in the socket on the Stemi mount.
•
Insert glass plate or B/W plastic plate (Fig. 10/7)
in the mount in the base of the stand.
To this effect, press the glass plate or the B/W
plastic plate against the spring (Fig. 10/8) and
make it lock in.
435063-7044-010
Stereo microscope
Installation of an additional reflected-
light illuminator has been described in
section 3.3.1 on page 19.
If necessary, the ease of motion of the
focusing drive can be set as required
on a case-by-case basis by adjusting
the two focusing buttons (Fig. 11/1
and 2) in opposite directions.
The ease of motion must not be set so
loosely that the drive moves down-
wards by itself. This might damage the
microscope or the specimen.
Stemi 305
04/2015