Güde BLACKLINE BL 460 BS Mode D'emploi Original page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
CLEANING
Wash the appliance thoroughly with water before it is used,
remove any grass and mud from inside – this will prevent dirt
from drying inside the appliance and problems the next time the
appliance is started.
One or two times a year, remove the gear housing and use a
brush or compressed air to clean the space around the belt
pulleys and drive belts.
Once in a season, you should clean the inside of the driving
wheels. Disassemble both wheels. Remove grass and dirt off
the geared wheels and their edges using compressed air or a
brush.
KNIFE DISASSEMBLY
To clean/sharpen/replace the knife
CAUTION: The spark plug must be disconnected before
disassembly.
Release the bolt when disassembling the knives.
Reassemble as shown in the picture. Tighten the bolts. Torque -
40 Nm. The bolt should also be replaced when replacing the
knives.
EMPTYING THE FUEL TANK AND CARBURETTOR
Put a container allowing fuel storage under the carburettor. To
prevent fuel spilling, use a funnel.
Remove the drain bolt and put the fuel valve tie rod to the ON
position.
Re-fit the drain bolt with a gasket ring when the fuel tank is
empty. Tighten the bolt.
STORING
Fuel must not remain in the fuel tank for more than 1 month.
Clean the mower at regular intervals and store it in a dry and
locked room.
ENVIRONMENT
For environment protection, a special attention should be paid to
the following points:
Use common pure unleaded fuel.
A funnel and/or can with level control to be used at all times
to prevent fuel from spilling when refuelling.
Do not fill the fuel tank up to the edge.
Make sure the engine oil does not overflow.
When changing oil, make sure the used oil is disposed
under the applicable regulations. Prevent oil spillage.
Do not put old oil filters to municipal waste – deliver them
to an appropriate collection centre.
Replace the absorber if defective. Original spare parts to
be used for any repair.
Contact a professional for any adjustment to the
carburettor.
Filter to be cleaned as instructed at all times.
After the mower service life has expired, we
recommended returning the appliance to the seller that
will dispose it in accordance with the applicable
regulations.
At regular intervals, check the level of wear and
technical condition of the mower.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

95315

Table des Matières