For Your Safety - Beta 3012 Mode D'emploi

Beta
INSTRUCTIONS
GB
ART. 3012
Engine bracket

For your safety

We recommend using this machine after reading the instruction manual carefully, keeping to the
instructions provided therein.
1. Do not exceed 500 kg load
2. Use lifting accessories suitable for the load to be supported and complying with UNI/DIN standards (see
Robur catalogue)
3. Use bolts equal to or higher than class 4.8
4. Tighten the bolts and make sure that the weight is suitably held
5. Make sure that the points of support are suitable for the weight to carry
6. Do not use while the engine is running
7. Check the state of the support before using it; replace it if irreparable damage has been caused
8. Do not modify the product; do not weld it in any way
9. Failure to follow the above rules may result in severe damage or injury
The tool is designed to support the engine, while removing its supports from the vehicle, using struts to carry its
weight.
We recommend not keeping the engine running or starting the engine with the mounted bracket.
Pack contents:
– 1 bracket
– 2 chains, 950 mm
– 2 supports with rubber guards
– 2 hooks that can be vertically adjusted through threaded nuts
Use:
Assemble the tool (see Fig. 1); place it on the vehicle, leaning the brackets with the rubber guards on the
suspension struts (see Fig. 2).
Connect the engine to the bracket, making sure that the chosen point can carry the weight, using the chains
supplied with the tool. If these should not be sufficient or adequate enough, use lifting accessories, including hooks,
eyebolts and eye nuts, certified for the load to be supported (see Robur catalogue).
WARRANTY
Beta Utensili SpA accepts no responsibility for damage caused by misuse or any use that is not in compliance with
the safety standards described herein.
Fig. 1 Fig. 2