Festool SSU 200 EB Notice D'utilisation D'origine page 20

Sword saw SSU 200 EB
Original instruction
Table of contents
1 Technical data ......................................... 21
2 Symbols ................................................... 21
3 Operating elements ................................ 21
4 Applications ............................................. 22
5 Safety instructions .................................. 22
6 Transport and delivery ............................ 26
7 Adjustment .............................................. 26
8 Preparation for use ................................. 27
9 Operation ................................................. 28
10 Accessories ............................................. 29
11 Service and maintenance ........................ 29
12 Environment ............................................ 31
13 Fault correction ...................................... 32
1 Technical data
System voltage
Network frequency
Rated input
Movable supply
Circuit breaker
Pre-selection of number of rotations
Constant electronics
Electric safety brake
Restricted circuit power
Automatic lubrication of the guide reglet
Speed of sprocket wheel at the electronics set
at the level of:
Maximum chain speed
Mutual inclination of the guide reglet
Weight (tool included)
Depth of the cut [Guide reglet 8" (20 cm)]
at 0°
at 15°
at 30°
at 45°
at 60°
Oil tank volume
Protection class
2 Symbols
Double insulation
Warning of general danger
GB
220 - 240 V ~
50 - 60 Hz
1600 W
H07RN-F
15 - 16 A
current protection
2200 - 4600 min
10.6 m/s
0° - 60°
6.5 kg
200 mm
190 mm
170 mm
140 mm
100 mm
~ 240 ml
Risk of electric shock
Use protective goggles!
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Do not expose to rain!
Unplug the cord immediately if it is cut or
damaged
Read the instructions
Acoustic output value
Not to be included in municipal refuse

Advice or tip
•
3 Operating elements
•
•
[1-1] Safety lock
•
[1-2] On/off button
•
[1-3] Guide ruler
[1-4] Guide bar cover
-1
[1-5] Manual clamp screw
[1-6] Guide runner
[1-7] Front auxiliary handle
[1-8] Oil gauge
[1-9] Oil cap
[1-10] Rotary suction adaptor
[1-11] Chain adjustment wheel
[1-12] Oil feed adjuster
[1-13] Clamping lever for reverse tilt lock
[1-14] RPM selector
II /
[1-15] Rear auxiliary handle
[1-16] Parallel stop
[2-1] Chain sprocket cover
[2-2] Fastening wheel
[2-3] Chain
[2-4] Guide bar
[2-5] Hole for tension bolt
21