Mixing Bowl - gourmetmaxx Z 09747 Mode D'emploi

Mixing bowl

The food being blended or cooked is processed and heated in the mixing bowl. For
reasons of safety, the device can only be switched on when the mixing bowl is properly
seated in the motor assembly and the lid is locked.
If the latch knob cannot be turned, the lid is probably not positioned properly. The
spout must be located in the slot of the lid (see section "Mixing bowl lid").
Taking the mixing bowl out of the motor assembly
ATTENTION!
■ Burn hazard! The metallic surface of the mixing bowl becomes hot during operation.
Do not touch it or use kitchen gloves.
• Turn the locking knob clockwise up to the stop. You can now remove the mixing bowl.
09747_de-en-fr-nl_V4.indb 43 09747_de-en-fr-nl_V4.indb 43
43
The marks in the mixing bowl indicate the fi ll quantities
in increments of 0.5 litres.
The maximum fi ll quantity of the mixing bowl
amounts to 2 litres. Do not exceed it! There is
a scalding hazard due to spraying of hot food being
blended. The mixing bowl could also overfl ow during
operation.
Fitting the mixing bowl in the motor assembly
1. Place the mixing bowl in the mixing bowl receptacle of the
motor assembly. Make sure that the parts marked with T
and Z in the fi gure extend into one another accordingly.
2. Turn the latch knob counter-
clockwise up to the stop. This
slides the latch over the edge
of the mixing bowl lid.
The device is now operational.
EN
04.01.2016 16:00:57 04.01.2016 16:00:57