Skoda EEA 400 001A Instructions De Montage page 27

8353_TAZNE_ZAR_FABIA/MN/.fm Page 26 Wednesday, September 8, 2004 9:17 AM
- 7a, 7b -
- Gradually tighten the M10 nuts (F
nally one after the other with a maximum of one turn each. Use the OK 16 socket
wrench.
Repeat this procedure until the blade of the cutting board (H
lower supporting board. The maximum torque moment is 30 Nm. The tightening of the
nuts causes the opening to be cut in the bumper.
- 8a -
- Unscrew the M10 nuts (F
the upper supporting board (l
(G ) and finally loosen the cutting board (H
1
completed opening.
- 8b -
- Unscrew the M10 nuts (F
the upper supporting board (l
and the cutting board (H
the bumper.
- 9a -
- After cutting, the edge of the cut opening is slightly pressed out onto the upper
painted side of the rear bumper.
- Press in the edge using the wooden peg (J) with light pressure along the entire cir-
cumference of the opening. Press the cut out part through the central opening of the
cutting board (H ) using the wooden peg -arrow-.
1
After the paper template has worn out, this cut out may be used as the template
in further assembly work.
- 9b -
- After cutting, the edge of the cut opening is slightly pressed out onto the upper
painted side of the rear bumper. Press in the edge using the wooden peg (J) with light
pressure along the entire circumference of the opening.
- Hit the clamping bolts with the hooks (E
mallet and remove the cut out piece.
This cut out may be used as a template.
Place the thus prepared bumper in a suitable place.
The assembly of the tow bar to the vehicle
- 10a -
- A protective cover has been assembled onto the support beam of the tow bar assem-
bly for the ·koda Fabia vehicle. The spacing of the openings (important for the
assembly to the vehicle) is 188 mm.
Black process 45.0° 141.0 LPI
, F ) on the upper supporting board (I
1 2
) and carefully disassemble the cutting assembly. Remove
1
). Then take out the lower supporting board and screws
1
) along with the cut out piece from the
1
) and carefully disassemble the cutting assembly. Remove
2
). Then take the lower supporting board and screws (G
2
) from the completed opening ong with the cut out piece of
2
) from the cutting assembly using a rubber
2
, I ) diago-
1 2
, H ) lies against the
1 2
)
2