Warnings - RPB Z-LINK Mode D'emploi

WARNINGS!

1. Ensure that the helmet is correctly
assembled in the configuration that
suits your application.
2. Never place the helmet or the auto-
darkening welding filter on hot surfaces.
3. Scratched or damaged safety lenses
should be regularly replaced with
genuine RPB
®
Before using the new safety lens, make
sure to remove any additional protection
film from both sides.
4. Use the RPB Z-LINK
®
temperature range of -10°C to +60°C
(14°F to 140°F) <90%rh.
5. Improper use of this respirator or
use not in accordance with this User
Instruction Manual may cause injury
or death. Improper use may also cause
life threatening delayed lung, skin
and eye disease. The RPB
Respirator is manufactured to protect
the operator's face and head against
sparks and hazardous ultraviolet and
infrared rays emitted during the welding
process. It is not intended to be used
as a protection against impact, flying
particles, molten metals, corrosive
liquids or hazardous gases.
6. Materials which may come into
contact with the wearer's skin could
cause allergic reactions to susceptible
individuals.
7. Respirator worn over standard
spectacles may transmit impact, thus
create a hazard to the wearer.
8. The RPB Z-LINK
®
provide hearing protection. Earplugs or
earmuffs must be properly fitted when
6
replacement parts.
only within the
®
Z-LINK
® ®
Respirator does not
®
exposed to noise levels that exceed
the government permissible exposure
levels.
9. Do not use this respirator until you
have been trained in the respirators
use, maintenance and limitations by
a qualified individual (appointed by
your employer) who has extensive
knowledge on the RPB
Respirator. All training must be in
accordance with this Users Instruction
Manual.
10. Before using this respirator ensure
your employer has determined that
airborne contaminant concentrations
do not exceed those allowed by
applicable government regulations
and recommendations for powered
air purifying respirators. Federal law
requires that the employer measures
and monitors airborne contaminant
levels in the work area.
11. If this respirator is used in confined
spaces, ensure the area is well
ventilated and that all contaminate
concentrations are below those
recommended for this respirator. Follow
all procedures for confined space
entry, operation and exit as defined in
applicable regulations and standards.
12. DO NOT WEAR this respirator if
any of the following conditions exist:
Atmosphere is immediately
dangerous to life or health.
You CAN NOT escape without
the aid of the respirator.
Atmosphere contains less
than 19.5% Oxygen.
Work area is poorly ventilated.
Z-LINK
® ®