RPB Z-LINK Mode D'emploi page 11

SUPPLIED AIR
FIGURE 2.3
Connect the EN14594, AS/NZS 1716
approved Z-LINK Air Supply Hose to a
®
breathing air source supplying EN12021 or
better quality air. Connect the respirator quick
disconnect fitting onto the Air Supply Hose.
FIGURE 2.5
With air flowing through the respirator adjust
the air pressure at the point of attachment to
the recommended pressure as specified in
the Breathing Air Pressure Table (page 9).
FIGURE 2.4
Connect the Air Supply Hose to the flow
control device.
Note: Check the hose connections for any air
leaks and tighten if necessary - replace any
worn parts.
FIGURE 2.6
Airflow in the apparatus must be above 170lt/
min and the yellow indicator is not visible
when the flow drops below this rate. DO NOT
use the apparatus when the indicator is not
showing.
The Indicator can be positioned high or low
on the jaw so it is clearly visible.
11