RPB Z-LINK Mode D'emploi page 15

HEAD HARNESS ADJUSTMENT
The head harness can be tightened or
loosened using the ratchet knob on the back
of the headband.
FIGURE 6.3
The position of the head harness can be
adjusted by loosening the screws that hold
the front bracket and sliding it forward or
backwards into the desired slot. Once in
position, tighten the screws.
FIGURE 6.1
The height of the head harness can be
adjusted at the four attachment points by
switching which of the three slots is used.
FIGURE 6.4
Airflow can be directed by positioning the
air flow director so that the air flows more
towards the visor or towards the face.
FIGURE 6.2
15