RPB Z-LINK Mode D'emploi page 16

SETUP AND USE
SIDE PADDING SYSTEM
Detach the head harness ratchet at the pivot
points.
FIGURE 7.3
Slide the tab on the side pad covers into
one of the three T-shaped slots in the head
harness depending on the desired height
of the side pads. Reinsert the ratchet pivot
points.
16
CONTINUED
FIGURE 7.1
Slide the ends of the head harness into the
slots on the side pad covers.
While wearing the Z-LINK
ratchet adjustment until the helmet and side
pads sit comfortably on the head and ears.
FIGURE 7.2
FIGURE 7.4
, tighten the
®