Maintenance / Changing Batteries - LIVARNO LUX Z31999 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Position „PIR":

Maintenance / changing batteries

To ensure good solar cell
regularly (see „Cleaning and care").
Change the batteries as follows:
Slide the switch
Loosen the cover screws
cross-tip screwdriver (see Fig. E).
Remove the back of the main unit.
Remove the batteries from the battery compartment
with new rechargeable batteries with the same technical data. Be sure
to insert the batteries in the correct direction. The correct polarity is
shown inside the battery compartment.
Close the back of the main unit and secure the cover screws.
12 GB/IE
power (eco mode). When fully charged, the
batteries will provide approx. 8 hours of light in this
setting.
The solar cell charges the batteries in sunlight. The
solar cell automatically switches the spotlight on
6
in twilight or the dark when the motion sensor
detects movement. The light ON time is preset to ap-
prox. 1.5 minutes. If additional movement is detected
during these 1.5 minutes, the light ON time will reset.
In this setting the LEDs will be fully powered. With the
batteries fully charged the charge on this setting will
provide light for a total of approx. 2 hours.
performance the solar cell must be cleaned
6
to the „OFF" position.
5
the back of the main unit
11
3
using a
1
and replace
10