Erreka VIVO-D201 Manuel De L'installateur page 66

STARTING UP AND PROGRAMMING
Programming the gate run ("P3"), operators without encoder

Before programming the run, adjust the
maximum thrust in accordance with the weight
and size of the gate (see "Maximum thrust
adjustment (parameter A6)" on page 64).
Failure to do so will mean the control board
cannot correctly detect any halting of the gate.
O
Before programming the gate open/close,
ensure the turning direction of the operator is
correct (see "Initial Conditions Programming
(D1= "C")" on page 60).
D1 D2 D3
P 3 O
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and V until D1 shows the letter
P flashing. Press ENTER to confirm. D2 flashes.
3 Press the buttons ^ and
parameter appears (D2=3).
4 Press ENTER. The gate carries out a reset and Oç
flashes in the display. Leaf 1 starts to open by itself.
Main Functions Programming (D1= "F")
D1 D2 Parameter
F 1
F u n c t i o n i n g
(opening mode is modified
using A9)
2 Standby in automatic mode
3
Pedestrian opening (%)
4
Pedestrian closing mode
a.
For further details, see "Functioning modes"
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
F flashing. Press ENTER to confirm. D2 flashes.
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
62
Installation Manual
D4
ç Programming the gate run
until the required D2
V
D3
0
a
m o d e
0..5.
0...5
0
on page 49.
until D1 shows the letter
V
until the required D2
V
5 Press ST1 to start slowdown for leaf 1 when
opening.
6 Leaf 1 automatically stops opening when reaching
the opening stopper or the FCA.
7 Press ST1 to start opening leaf 2.
8 Press ST1 to start slowdown for leaf 2 when
opening.
9 Leaf 2 automatically stops opening when reaching
the opening stopper or the FCA.
10 Press ST1 to start closing leaf 2.
11 Press ST1 to start slowdown for leaf 2 when closing.
12 Leaf 2 automatically stops closing when reaching
the closing stopper or the FCC.
13 Press ST1 to start closing leaf 1.
14 Press ST1 to start slowdown for leaf 1 when closing.
15 Leaf 1 automatically stops closing when reaching
the closing stopper or the FCC.
16 When programming is finished, D3-D4 stop flashing
(remain static) and D2 flashes.
17 Press ESC to return to the previous display.
Pre-
D4 determined Options or values
option
1...3 01 01: automatic closing, collective opening
02: step-by-step closing, step-by-step opening
03: dead man mode
0...9 03 59 = 59 sec; 2.5 = 2 min. 50 sec., etc
0 40 00: pedestrian opening is not carried out,
10: 10% of total opening, etc
1,2 01 01: automatic, 02: step-by-step
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm.
5 Press ESC to return to the previous display.

Operating mode, programmed using F1, can be
modified using A9 (see "Advanced Functions
Programming (D1= "A")" on page 63).
until the required D3 and
V