Functioning Modes - Erreka VIVO-D201 Manuel De L'installateur

24Vdc battery (bA)
It is possible to connect a battery in order for the
operator to continue working in the event of a drop in
power. The battery will be recharged when the
electricity supply is restored.
3

FUNCTIONING MODES

Automatic mode (F101)
Opening: this begins by activating the key device
(magnetic key, key switch, transmitter, etc).
• Collective opening (A901): during opening, the
control board does not obey key commands (the
gate cannot be halted using key devices).
• Step-by-step opening (A902): if a key command is
sent during opening, the gate comes to a halt. A key
command must be sent to close it. A new key
command after closing produces a reset (rS).
Step-by-step mode (F102)
Opening (with alternative shutdown): this begins
by activating the key device (magnetic key, key switch,
transmitter, etc).
• Step-by-step opening (A901, A903): if a key
command is sent during opening, the gate comes to
a halt. A key command must be sent to close it. A
new key command after closing produces a reset
(rS).
Dead man mode (F103)
DESCRIPTION OF THE PRODUCT
The battery must be connected to the control board
t h r o u g h a c h a r g e r , a s e x p l a i n e d i n " B a t t e r y
connection" on page 58.
• Opening with alternative shutdown (A903): if a
key command is sent during opening, the gate halts
and remains open for the programmed time. If a key
command is sent during standby, standby time
starts again. A new key command after closing
produces a reset (rS).
S t a n d b y : t h e g a t e r e m a i n s o p e n d u r i n g t h e
programmed time (except with the option A902, which
remains open until a key command is received). The
effect of activating the photocells or key device during
standby depends on the parameters A8 and A7
respectively.
Closing: the closing operation starts once stand-by
time is finished.

If the key device is operated during closing, the gate
halts, reverses operation direction and then opens
completely.
• Collective opening (A902): during opening, the
control board does not obey key commands (the
gate cannot be halted using key devices).
Standby: the gate remains open indefinitely until the
key device is operated.
Closing: the closing operation starts when the key
device is operated.

If the key device is operated during closing, the gate
halts, reverses operation direction and then opens
completely.
Opening: this is done by continuously operating the
ST1 key device (magnetic key, key switch, pushbutton,
etc). The radio transmitter cannot be used in this case.
Standby: the gate remains open indefinitely until the
key device is operated.
Closing: this is done by continuously operating the ST2
key device (magnetic key, key switch, pushbutton, etc).
The radio transmitter cannot be used in this case.
49
VIVO-D201 Control board