Table des Matières
Publicité
Instructions of use
1. Connect all the accessories as shown in the
illustration above.
2. Press the power switch ON/OFF, number 4 on the
picture, and the LCD screen will be on.
Numeración
Accesorio/Conexión
1
Body probe
2
Facial probe
Hand probe
3
4
On/Off button
5
AC Power cable
3. Select the desired function and press ENERGY
button to adjust the energy level, then press TIME
button to set the operation timer. Press STATE button
to choose the wave type as needed.
4. Clean the treatment area.
5. Apply speci c gel or serum to body parts to keep
skin hydrated prior to treatment. Please ensure that
the electrode is in touch with the skin of the patient as
much as possible to avoid the accumulation of
currents which will cause skin irritation or redness.
Add half bottle (1 ml) or wrinkle removal serum on the
face, including the eye area.
6.Set timer to 15 min.
Treatment plans:
A. 30 min. for facial treatment. If this is the rst
treatment for the patient, 15 min. for each side of the
face is suggested.
B. 10 min. for the eyes.
C. 30 min. for the breast and other parts of the body.
The total treatment time for the whole body should not
exceed 1h30 each time.
7. Choose the appropriate probe size, energy level and
output waves.
8. Put 2 ml of high resistance wrinkle removal cream
on top, bottom, left and right side of the face without
spreading the cream, or choose to put the cream on,
before the treatment of the particular area.
9. After adjusting the above settings, press STAR-
T/PAUSE button to begin the treatment.
10. Once you release the foot controller, the electrode
will stop working.
Publicité
Table des Matières
