Transport / Storage; Disposal; Troubleshooting - Zipper Maschinen ZI-STE6700DH Mode D'emploi

•
Drain the dirty oil into a suitable container.
•
Fix the oil outlet screw again.
•
Fill in new engine oil
•
Check the engine oil level with the dipstick
•
If the level is correct reinsert the dipstick

Transport / Storage

14.1.2
In order to avoid the generator leaking oil during transport or temporary storage, make sure to
switch off the generator, keeping it at a standing pose under normal operations. After the engine is
totally cooled, turn the ventilating pole of the fuel-filling lid to the "OFF" position thoroughly.
When transporting the generator:
Do not let the fuel spill out of the fuel tank. (The top of the fuel-filling tank should have no fuel.)
When the generator is placed on a vehicle, do not run the engine. You should take the generator
down from the car before operation.
When you take the generator to the car, avoid exposing it to sunshine. If it is put in sealed
carriage for a long time, the high temperature of the carriage may cause the fuel to boiling
away, thus leads to burn.
Before the generator is put into a long-time storage, you should:
Make sure the storage area is clean and dry.
Store the machine with closed inlet- and outlet valves. Therefore, pull on the rope of
the starter until you fell resistance.

14.2 Disposal

Do not dispose of the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.

15 TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Always stop the machine before carrying out any conversion,
adjustment, cleaning or maintenance work and secure it against unintentional restarting
and wait until the machine has cooled down
If you find yourself unable to carry out necessary repairs properly and/or do not have the required
training to do so, always consult a specialist to fix the problem.
Trouble
Engine will not start
up
Engine runs
unevenly
Motor too little
power
Low output voltage
under load
Uneven Output
voltage
High noise level
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE6700DH & ZI-STE7500DSH
NOTICE
WARNING
Reason
 Fuel cock closed
 No fuel
 Too little oil in the tank
 Air in fuel pipeline
 Battery too weak
 Wrong fuel
 Air in fuel pipeline
 Dirty air filter
 Too much load available
 Unbalanced load available
 Loose screw connections
TROUBLESHOOTING
Shooting
 Set fuel cock in position "ON"
 Refill fuel
 Refill oil
 Have the fuel pipeline blown through
 Charge the battery with appropriate
charger
 Use correct fuel
 Have the fuel pipeline blown through
 Clean the filter elements, possibly
exchange
 Reduce existing load
 Disconnect all electrical consumers.
Then apply again individually to
determine which consumer causes
the uneven loads.
 Tighten all screws
28