Maintenance And Cleaning; Cleaning; Oiling The Saw Chain - Grizzly AKS 4035 Lion Set Traduction De La Notice D'utilisation Originale

GB
H I J
R S T
5. As you approach the felling cut
on the stay the tree should start
falling. If it becomes apparent
that the tree may not fall in the
required direction or is lean-
ing back, and the saw chain is
jamming, stop felling and use
wedges made of wood, plastic or
aluminium to open the cut and to
I J
tilt the tree in the required felling
line.
S T
6. If the trunk diameter is larger
than the length of the chain bar,
make two cuts.
For safety reasons, we advise in-
experienced users not to fell any
logs with a rail length which is
smaller than the trunk diameter.
7. After carrying out of the back cut,
the tree falls by itself or with the
aid of the felling wedge or crow-
bar.
As soon as the tree begins to
fall, pull out the saw from the
section, stop the motor, place
the chainsaw down and leave the
workplace using the withdrawal
path.
Pay attention to falling branches
and do not stumble.
Maintenance and

cleaning

Remove the battery prior to ser-
vicing the appliance.
Danger of injury!
Leave any
vicing work not covered by this
manual to our Service-Center.
Use only original spare parts.
Allow the machine to cool down
before all maintenance and
106
maintenance and ser-
cleaning works. Danger of burn
injuries!
Use cut-protection gloves when
handling the chain or the chain
bar.
Risk of cuts!
Remove the battery from the unit
before servicing it.
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid accidents.
• Keep the gripping handles free of
petrol, oil or grease. Clean the grip-
ping handles, where appropriate, with
a moist cloth soaked in soap. Use no
solvents or petrol for cleaning!
• Clean the saw chain after every use.
Use a paint brush or wipe for that. Do
not use any liquids to clean the chain.
After cleaning, oil the chain lightly with
chain oil.
• Clean the ventilation slots and the
surfaces of the machine with a paint
brush, whisk or dry cloth. Do not use
any liquids for cleaning.

Oiling the saw chain

Clean and oil the chain regularly.
In this way, you keep the chain
sharp and get optimum machine
performance. In case of damage
due to inadequate maintenance of
the saw chain, the guarantee claim
is invalid. Use cut-protection gloves
when you are handling the chain or
the chain bar.
• Oil the chain after cleaning, after 10
hours of use or at least once weekly,
depending on which comes first.