KS Tools 550.1710 Notice D'utilisation page 21

8. Error/Cause tables
THE PROBLEM
You connect to the charger for 20 hours and there is no
charge in charge level.
Charge level reads low, but when the AC adaptor is
plugged into the Battery Booster, the needle flicks right.
The Battery Booster is fully charged but has no power.
The report "Er0" appears in the display.
The report "Er1" blinks in the display and an audio war-
ning signal can be heard
The report "Er2" appears in the display and an audio
warning signal can he heard.
QUESTION
How many Jump Starts can a fully charged Battery
Booster do before needing to be recharged?
What is the ideal in use storage temperature of the
Battery Booster?
9. Disposal
- Disposal or recycling must be carried out according to the respective country legislation.
- Prior to separation parts must be cleaned and disassembled according to the current working and environmental
regulations.
- Lowering of environmental pollution and the preservation of the environment should be the middle point of all
activities.
THE SOLUTION
Check charger to see if it is charging.
Charger should be warm.
Check all wire connections.
The internal battery of the Battery Booster needs to be
replaced.
Check where the wires meets the jaw on the Battery
Booster clamp.
Make sure they are well crimped.
The battery has discharged.
The Booster has been incorrectly connected to the batte-
ry poles (connected in reverse)
Problem with the vehicle battery. Check the battery of the
vehicle that requires starting.
ANSWER
Between 1 and 20 depending upon operating factors
such as temperature, general condition of the vehicle,
engine type and size.
Room temperature. The Battery Booster will also operate
at temperatures below zero, its power however will be
lessened. Intense heat will activate self charge.