The manufacturer is not liable for persons and/or damage to property, which can be attributed to incorrect
utilization of the device!
5. Technical data
Characteristics
Voltage
Selector switch
Cranking Amps CA
Peak Amps
Battery
Battery lifetime
Charge control display
Charging time
Scope of utilization
Charging device
Charge voltage
Charge current
weight
Other characteristics
Incorrect connection protection
Safety switching
Protection against power surges
Housing
IP Protection classes
Automatic charging device
Booster
Cable length
Cable storage
Cable cross section
High performance copper clamps
Clamps
Start attempts when fully charged
6. Application
6.1 Switching on/Utilization
ATTENTION: The battery booster must be charged for a minimum of 72 hours prior to first utilization! The first
charging must be carried out with the supplied automatic network-charging device!
Check, by operating the red pressure switch on the front of the device the charge condition of the battery. A minimum
of one green bar must illuminate on the coloured bar display on the lower part of the display. So that all possible
damages to the Booster are avoided it must be noted that the Booster is not completely discharged!
Information when connecting to a 12/24 Volt vehicle battery
ATTENTION: Prior to connecting the Booster to any vehicle which on-board voltage is present and if there is more
than one battery if a series or parallel switching exists. Always check the manufacturers guidelines prior
to jump-starting the vehicle!
550.1710
12 V
Nein
700 A
2200 A
1x22Ah sealed lead acid battery
approximately 600 cycles
Digital Voltmeter by at the touch of a
button
up to 6 h
Car/transporter
Otto and Diesel (up to max.2,5 L)
Automatic network charging device
230V~50HZ
12V - 4000mA
approximately 10 kg
optical and acoustic
Current flow only after clamping
Yes
Pb with rubberised base area
IP 20
IP 20
1600 mm
on the sides of the housing
35 mm²
Yes
complete insulation up to 1000 A /
L=190mm
max. 20
550.1720
12/24 V
12 - off - 24 V
1400 / 700A
4400 / 2200A
2x22Ah sealed lead acid battery
approximately 600 cycles
Digital Voltmeter by at the touch of a
button
bis zu 12 h
Car/transporter/ NFZ
Otto and Diesel
Automatic network charging device
230V~50HZ
12V-4000mA
approximately 18 kg
optical and acoustic
Current flow only after clamping
Yes
Pb with rubberised base area
IP 20
IP 20
1600 mm
on the sides of the housing
35 mm²
Yes
complete insulation up to 1000 A /
L=190mm
max. 20