Troubleshooting - Mi-T-M GEN-3200-iMS0 Manuel D'utilisation

When generator engine fails to start after several attempts, or if no electricity is available at the output socket, check
the following chart. If your generator still fails to start or generate electricity, contact your nearest Mi-T-M Customer
Service Representative or service shop for further information or corrective procedures.
Symptom
Engine will not start.
Generator has no output.
Operator's Manual

Troubleshooting

Problem
Check if engine switch is off.
Fuel Tank empty.
Check to make sure generator is not
connected to an appliance.
Check spark plug for loose spark
plug cap.
Check spark plug for contamination.
Check engine oil level.
Check if the "O_Lod", overload,
is indicated in the Multi Monitor.
Check if the DC circuit breaker is
turned off.
Check AC receptacle and DC terminals Secure connection if necessary.
for loose connection.
Check to see if engine starting was
attempted with appliances already
connected to generator.
Solution
Turn engine switch to the "
(CHOKE) position.
Fill tank making sure not to overfill.
If connected, turn off the power switch
on the connected appliance and
unplug.
If loose, push spark plug cap back
into place.
Remove spark plug and clean
electrode.
If the engine oil level is low, add oil
per "Pre-Operation; Engine Oil" on
page 2.
Stop the engine and check the
appliance and/or generator for
overloading.
Depress the circuit breaker into
ON position, after making sure the
charging current level is proper and
the battery is in the normal condition.
Turn off switch on the appliance, and
disconnect cable form receptacle.
Reconnect after generator has been
started properly.
"
33