Using Electric Power; Control Panels - Mi-T-M GEN-3200-iMS0 Manuel D'utilisation

OPERATION

USING ELECTRIC POWER:

WARNING: MAKE SURE THAT THE APPLIANCE IS
SWITCHED OFF BEFORE CONNECTING IT TO
THE GENERATOR.
DO NOT MOVE THE GENERATOR WHILE IT IS
RUNNING.
BE SURE TO GROUND THE GENERATOR.
FAILURE TO GROUND UNIT MAY LEAD TO
ELECTRICAL SHOCK.
AC APPLICATION:
. Make sure the voltage indicated in the LED screen is the
normal level (approx. 20V).
NOTE: This generator is thoroughly tested and adjusted in
the factory. If the generator does not produce the specified
voltage, consult your nearest authorized Mi-T-M Customer
Service Representative
2. Turn off the switch(es) of the electrical appliance(s) before
connecting to the generator.
3. Insert the plug(s) of the electrical appliance(s) into the
receptacle. (Fig. )
• Using Table , check the amperage of the receptacles used
and be sure not to take a current exceeding the specified
amperage.
• Be sure that the total wattage of all connected appliances
does not exceed the rated output of the generator, see
specifications on page 30.
WARNING: TO TAKE POWER OUT FROM THE TWIST
LOCK RECEPTACLE, INSERT THE PLUG INTO
THE RECEPTACLE, AND TURN IT CLOCKWISE
TO THE LOCK POSITION.
BE SURE TO GROUND THE GENERATOR IF THE
C O N N E C T E D E L E C T R I C A L D E V I C E I S
GROUNDED.
DO NOT PUT FOREIGN OBJECTS INTO THE PLUG
RECEPTACLE.
NOTE: When the "O_Lod" (overload) is indicated in the
LED screen, AC output is cut off on the grounds that
the generator operation is in overload condition or
appliance(s) will be out of order.
Stop the generator immediately, check the appliance
and/or generator for overloading, and have repaired as
necessary by an authorized Mi-T-M Customer Service
Center.
4. Turn on the switch of the appliance.
28
Operating the Generator
GEN-3200
AC-G3200i
Engine Switch
GEN-4300
AC-G4300i
Engine Switch
Style

CONTROL PANELS

Multi Monitor AC Receptacles (20A)
Key Switch AC Circuit Breaker DC Circuit Breaker
Multi Monitor AC Receptacles (20A)
Key Switch AC Circuit Breaker DC Circuit Breaker
(Fig. )
Ampere Receptacle AC
plug
Up to NEMA NEMA
20A 5-20R 5-20P
Up to NEMA NEMA
30A 5-30R 5-30P
Table 
AC Receptacles (30A)
DC Terminals Ground Terminal
AC Receptacles (30A)
DC Terminals Ground Terminal
Description
GFCI (Ground
Fault Circuit
Interrupter)
Receptacle,
duplex
Locking
Receptacle
Operator's Manual