Mi-T-M GEN-3200-iMS0 Manuel D'utilisation page 6

F. WHERE TO OBTAIN WARRANTY SERVICE
It is recommended that warranty service be performed by the authorized
dealer who sold you the engine, although warranty service will be
performed by any authorized service dealers or warranty stations
anywhere in the United States.
When warranty repair is needed, the engine must be brought to an
authorized service dealer or warranty station's place of business during
normal business hours. In all cases, a reasonable time, not to exceed
30 days, must be allowed for the warranty repair to be completed after
the engine is received by the authorized service dealer or warranty
station.
G. MAINTENANCE, REPLACEMENT AND REPAIR OF
EMISSION-RELATED PARTS
Only warranted engine replacement parts approved by FUJI should
be used in the performance of any warranty maintenance or repairs
on emission-related parts. If other than authorized parts are used for
maintenance, replacement or repair of components affecting emission
control, you should assure yourself that such parts are warranted by
their manufacturer to be equivalent to authorized parts in performance
and durability. FUJI, however, assumes no liability under this warranty
with respect to parts other than authorized parts. The use of non-
authorized replacement parts does not invalidate the warranty on
other components unless the non-authorized parts cause damage to
warranted parts.
I. MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2005 and later
Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. FUJI will not deny
a warranty claim solely because you have no record of maintenance; however, FUJI may deny a warranty claim if your failure to perform required
maintenance resulted in the failure of warranted part. The proof which you maintain should be given to each subsequent owner of the engine. You are
responsible for performing the scheduled maintenance described below based on the procedures specified in the 2005 and later Owner's Manual.
The scheduled maintenance below is based on a normal engine operating schedule.
PROCEDURE:
. Change engine oil.
2. Clean air cleaner (element).
3. Replace air cleaner element.
4. Clean and adjust spark plug and electrodes. 4. Every 200 hours.
NOTE: More frequent maintenance may be necessary under dusty, dirty or severe conditions.
6
Introduction
H. PARTS COVERED UNDER THE CALIFORNIA EMISSIONS
WARRANTY
. Fuel Metering System
2. Air Induction System
3. Ignition System
4. Exhaust manifold, if applicable.
5. Miscellaneous items used in above systems.
INTERVAL:
. Initial 20 hours and every 00 hours afterward.
2. Every 50 hours.
3. Every 200 hours.
a. Carburetor and internal parts (and / or pressure regulator or fuel,
injection system).
b. Air / fuel ratio feedback and control system, if applicable.
c. Cold start enrichment system, if applicable.
d. Regulator assembly (gaseous fuel, if applicable).
a. Intake manifold, if applicable.
b. Air filter.
a. Spark Plug.
b. Magneto or electronic ignition system.
c. Spark advance / retard system, if applicable.
a. Electronic controls, if applicable.
b. Hoses, belts, connectors, and assemblies.
c. Filter lock assembly (gaseous fuel, if applicable).
Operator's Manual