During Operation - Ribimex Ribiland PRBVB2800 Manuel D'instructions Et D'utilisation

V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens.
- The product is designed to shred garden debris such as clippings and small twigs within the limits of
its characteristics (smaller than 40mm in diameter).
It is not to be used for any other purpose outside of the described scope in this manual.
- It is recommended to use the product only on dry surfaces, do NOT operate on damp or wet working
area.
- Do not use the machine for unsuitable purposes (for ex. for shredding other materials such as plastic,
paper; metal...)
- The tool is not intended for artisanal, commercial, professional or industrial use (ex.: in public
parks...).
5.2- Operation
BEFORE any operation:
-- Always visually inspect that the product does not show signs of use or damage. Replace any used
or damaged part.
-- Check that the screws, bolts and nuts are well tightened. Tighten firmly the screws, bolts and nuts
when needed.
-- Ensure that the collection box is properly and securely installed.
-- Ensure that the machine is only connected to conventional sockets with a 230-240V alternating
current supply.
-- Only use extension cables, if they are really necessary, intended for outdoor use and approved.
The use of extension cables may cause a drop in voltage, which will result in the machine not
performing to its peak or the motor overheating.
-- Look into the feeding chamber to make sure it is empty. Do NOT start machine before clearing any
material still present in the feeding chamber.

DURING operation

-- Keep proper balance and footing at all times. Do not over reach. Never stand at a higher level than
the base of the machine, when feeding material into it.
-- Always keep your fingers and hands away from the feeding chamber. Use the push stick to push in
the material.
-- When feeding material into the machine be extremely careful that pieces of metal, rocks, glass
bottles, cans or other foreign objects are not included.
-- If the cutting mechanism strikes any foreign objects or if the machine should start making any
unusual noise or vibration, switch off the machine and allow it to come to a complete stop, disconnect
the plug from the power source, and take the following steps:
- Inspect the machine for damage.
- Check for and tighten any loose parts.
- Have any damaged parts replaced or repaired by an authorized service center with original parts.
-- Always stand clear of the discharge zone when operating this machine.
Do not allow processed material to build up in the discharge zone; this may prevent proper discharge
and can result kickback of material through the feed intake opening. Empty the collection box
regularly.
-- Do not transport this machine while the power source is running.
-- Switch off the machine and disconnect the plug from its power source whenever you leave the
work area.
-- Do not tilt the machine while in operation.
-- Motor should be kept clean of debris and other accumulations.
Page 21 / 35