Technical Data - Sirius SU900 Notice D'instruction

SUT900 (Fig. 14)
Remote control
A: At every selected function, the led li
ghts on accordingly.
B: To increase the speed.
C: To switch on the lights or to switch
them off.
D: ON/OFF To go from a higher speed
back to first one press twice the but
ton: To switch the hood on or off
press once this button.
E: To reduce the speed.
F: To set the timer.
fig. 14
The led on the right side will start (eve-
ry 5 seconds), the hood will work for 10
minutes at the selected speed and then
it lights automatically off. If the client in-
creases or reduced the speed while the ti-
mer is on, this is automatically stopped.

TECHNICAL DATA:

Alkaline battery powered: 12v mod. 23A
Operating frequency:
Combinations:
Max. consumption:
Operating temperature:
Standard configuration.
If two cooker hoods-radio control system
are installed in the same room or in the
immediate vicinity, each system may af-
fect the operation of the other, due to the
fact that they have the same code. The-
refore it will be necessary to change the
code of one of the radio controls.
Generating a new transmission code.
The radio control is supplied by the ma-
nufacturer with default codes stored. If
you want to create a new set of codes,
proceed as follows: press and hold the
UP, STOP and DOWN buttons simulta-
neously for 2 seconds. After the LEDS li-
ght up, press the UP and DOWN buttons
within 5 seconds. The LEDS will flash 3
times to indicate that the process is com-
pleted. WARNING: This procedure dele-
tes all previously-stored codes.
Learning the new transmission code.
After changing the transmission code
on the radio control, the cooker hood
electronic control unit must be made
to set the new code as follows: press
the main Power Off button on the coo-
ker hood and then restore power to the
electronic control unit. Within the next 15
seconds, press the Light button. This will
ensure the control unit is synchronized
with the new code.
433.92 Mhz
4096
25Ma
-20° : +55°C
11