Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister MES480-1 Traduction Du Manuel D'utilisation Original

the left to loosen, move the handle to
the required position, then tighten the
screw by turning to the right.
Attaching the sandpaper (Figure 3)
CAUTION! Switch off the
machine, disconnect the power.
The sanding plate is fitted with a hook
and loop system for sanding sheets.
This enables rapid application of new
sheets without the need for a tensioning
system. Before applying a new sheet,
tap the dust from the hook and loop fas-
tening of the sanding plate. Stretch the
sandpaper taut over the sanding plate
(6) and ensure that the dust extraction
holes of the sanding plate and discs
match up. Stretch the sanding paper
over the sanding plate (5) and ensure
that the holes (4) of the plate and the
disc match up.
Dust extraction (Figure 4)
Connect the dust collection
bag (4) to the dust extraction
connector (5). Check the filling
level, and empty frequently.
Always work with a dust extraction sys-
tem connected!
8 – Operation
Switching on and off
Connect the plug to a power socket.
• Switch on continuous operation:
Press button (2) [I].
• Switch off continuous operation:
Press button (2) [0].
MW-5457200-Bedien-2005.indd 41 MW-5457200-Bedien-2005.indd 41
9 – Mode of operation
CAUTION! Only carry out work
with a light pressure.
Sanding
Position the entire sanding surface on
the piece of work.
Switch the machine on and guide it over
the surface to be sanded using circular
motions. Do not apply additional pres-
sure to the machine when sanding, the
weight of the machine itself is usually
sufficient to ensure optimum revolutions
and a good result. Do not tip! Complete
several sanding processes using sand
paper that gradually gets finer.
Polishing
Apply polish using a cross-coat method
and allow to dry slightly before polish-
ing. When you have completed your
work, reduce the pressure, lift the
machine from the piece you are working
on, and then switch the machine off.
10 – Maintenance and envi-
ronmental protection
CAUTION! Before performing
any care or maintenance work,
disconnect from the power.
Use a dry brush to clean the dust
extraction openings. Clean the housing
with a damp cloth only - do not use sol-
vents! Then dry well. Remove the dust
collection bag from the plastic section
to empty. Empty carefully, try not to cre-
ate dust. Do not breathe in saw dust!
Wash out the bag in cold soapy water
and allow to dry.
41
07.05.20 12:20 07.05.20 12:20