Additional Handle; N : 4000- 14000 Min; Installation And Setting - Meister MES480-1 Traduction Du Manuel D'utilisation Original

• Observe the general safety notes for
handling electrical tools.
• Switch the device off and pull the
plug out of the socket if the connec-
tion cable is damaged. A damaged
cable must be replaced by the manu-
facturer or by their customer service
or a similarly qualified person.
Type plate
Observe the technical specifications
detailed on the type plate! The specifi-
cations have the following meanings:
MES480-1
WU5457200
230 V~/50 Hz Voltage and frequency
480 W
n : 4000–
0
14000 min
-1
Address of the manufacturer
Conmetall Meister GmbH
Oberkamper Straße 39
42349 Wuppertal
BJ
SN:
SN: XXXXX
40
MW-5457200-Bedien-2005.indd 40 MW-5457200-Bedien-2005.indd 40
Model designation
Article number
Max. power consumption
Revolutions in idle
„geprüfte Sicherheit"
seal of quality (tested
safety)
CE mark (conformity
with European safety
standards)
Do not dispose of with
the household waste!
Year of construction
Serial number
The first two underlined
numbers give the month
of manufacture.
Safety marks
Pay attention to the safety marks! The
symbols have the following meanings:
Wear safety goggles!
Read the operating instruc-
tions!
Wear ear defenders!
Always work with a dust col-
lection system connected!
Double insulated!
7 – Installation and setting
Revolution regulation/Revolution
pre-selection function (Figure 1)
The machine has an electronic function
for controlling the revolutions. Activating
the switch (1) enables continuous modi-
fication of the revolutions within the
specified values, for example, to enable
a gentle start.
The adjustment wheel (8) for pre-select-
ing the revolutions allows you to select
the revolutions suitable for the material
in question, (+) = increases the revolu-
tions, (–) = decreases the revolutions.
Additional handle (Figure 2)
The additional handle (7) serves to
ensure safe handling and guidance of
the machine during sanding. The handle
can be smoothly adjusted to the most
practical position for working. Turn the
wing screw on the additional handle to
07.05.20 12:20 07.05.20 12:20