320 W; N = 6 000-12000 Min; Installation And Setting; Operation - Meister MFS320-1 Traduction Du Manuel D'utilisation Original

5456230-Schwingsch_man 30.01.15 09:08 Seite 39
Bj. Year of construction
SN Series number
230-240 V~/
50 Hz Voltage and frequency

320 W

Max. power consumption
n : 6000–
0
-1
12000 min Revolutions in idle
Voluntary seal of quality
(tested safety)
CE mark (conformity with
European safety standards)
Do not dispose of with the
household waste!
Address of the manufacturer
Safety marks
Pay attention to the safety marks! The
symbols have the following meanings:
When carrying out work in
which dust is generated,
wear a face mask and safety
goggles - do not smoke and avoid
naked flames.
Read the operating
instructions!
Wear safety goggles!
Always work with a dust
collection system connected!
Double insulated!
All manuals and user guides at all-guides.com
7 – Installation and setting
Insert Abrasive Sheets
Switch off machine. Pull out the mains
plug. Release clamping fixtures (5)
holding sanding sheet. Place sanding
sheets tightly over the sanding pad (6),
making certain that the holes (4) in pad
and patch line up. Fold over projecting
paper and clamp in place with the
clamping devices for sandings (Fig. 2).
Dust removal
into the dust extraction connection.
Preselecting the oscillation frequency
(Fig. 3)
The tool has an electronic control system
for preselection of the oscillation frequency
suitable for the material concerned. To
preselect the oscillation frequency, turn the
thumbwheel (8) to a position between 1,
lowest frequency, – e.g. for light pre-
sanding – and MAX, highest frequency.
For non-binding recommended settings,
see fig. 4.
8 – Operation
ON/OFF
Insert mains plug into an outlet
• On: Push the switch (1) to the right.
• Off: Push the switch to the left.
The device has an integrated dust
extraction system. Plug the
supplied dust collection box (4)
39