Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister MES480-1 Traduction Du Manuel D'utilisation Original

5457200-Exzentersc_man 27.03.15 09:58 Seite 41
Stretch the sanding paper over the sanding
plate (5) and ensure that the holes (4) of the
plate and the disc match up.
Dust extraction (Figure 4)
Connect the dust collection
bag (4) to the dust extraction
connector (5). Check the filling
level, and empty frequently.
Always work with a dust extraction
system connected!
8 – Operation
Switching on and off
Connect the plug to a power socket.
• Switch on continuous operation:
Press button (2) [I].
• Switch off continuous operation:
Press button (2) [0].
9 – Mode of operation
CAUTION! Only carry out work
with a light pressure.
Sanding
Position the entire sanding surface on
the piece of work.
Switch the machine on and guide it over
the surface to be sanded using circular
motions. Do not apply additional pressure
to the machine when sanding, the weight
of the machine itself is usually sufficient
to ensure optimum revolutions and a
good result. Do not tip! Complete several
sanding processes using sand paper that
gradually gets finer.
Polishing
Apply polish using a cross-coat method
and allow to dry slightly before
polishing. When you have completed
your work, reduce the pressure, lift the
machine from the piece you are working
on, and then switch the machine off.
10 – Maintenance and
environmental
protection
CAUTION! Before performing any
care or maintenance work,
disconnect from the power.
Use a dry brush to clean the dust
extraction openings. Clean the housing
with a damp cloth only - do not use
solvents! Then dry well. Remove the
dust collection bag from the plastic
section to empty. Empty carefully, try
not to create dust. Do not breathe in
saw dust! Wash out the bag in cold
soapy water and allow to dry.
Before each use, check the machine, the
cable and accessories to ensure that they
are not damaged. Have any necessary
repairs completed by a specialist.
Machines that no longer function properly
should be disposed off correctly in
accordance with the local regulations.
CAUTION! Electrical and battery
operated units that no longer
work should not be disposed of in the
household waste! They are to be
collected separately, in accordance
with the 2012/19/EU directive for the
disposal of electrical and
electronic waste, and
sent for proper and
environmentally-friendly
recycling.
41