Abrasive; Maintenance And Care; Vanes; Sanding Pad Brake - Festool LEX 2 150/3 Guide D'utilisation

Self-adhesive abrasives, such as Stickfi x sand-
paper, and sanding cloths can be affi xed to the
Stickfi x sanding pads.
To affi x the abrasive, simply press it onto the sand-
ing pad and remove it after use.
the pad and the holes aligned with those on the
sanding pad.
the compressed air supply before doing any work
on the tool.
Any maintenance or repair work requiring the
motor housing to be opened may only be carried
out by an authorized service workshop.
We recommend that the vanes on the motor be
replaced after approx. 500 operating hours.
The collar (5.1) makes contact with the sanding
pad, thus preventing uncontrolled vibration of the
sanding pad. This collar wears out over time and
must be replaced should brake fading occur. The
sanding pad must be removed for this. You can
5.3
then remove the collar from the snap-on fastener
(5.2) and replace it with a new one.
5.4
If the tool has not been used for an extended pe-
5.2
riod, such as a weekend, introduce 1 or 2 drops
of lubricating oil into the compressed-air supply
(5.3) on the tool prior to use.
5.1
The silencer on the IAS 2 connecting piece must
5
be replaced at regular intervals to maintain the
power of the pneumatic tool.
8

Abrasive

The abrasive must be centered on

Maintenance and care

Always disconnect the tool from

Vanes

Sanding pad brake

Lubrication

Replacing the silencer