Starting; Tool Settings; Speed Adjustment; Suction Unit - Festool LEX 2 150/3 Guide D'utilisation

3.1 3.2
4.1
4.2
Pressing the lever (3.1) switches on the pneu-
matic tool. Releasing the lever switches the tool
off again.
the compressed air supply before doing any work
on the tool.
3
You can regulate the sanding speed steplessly
between 6,500 and 8,000 rpm using the adjusting
wheel (3.2). This enables you to optimize the speed
to suit the material.
Sanding dust is extracted through the extraction
channels in the sanding pad and taken di-rectly to
the material removal point. To ensure optimized
dust extraction, we recommend using a Festool
dust extractor with automatic switch-on/switch-
off device for compressed-air tools.
pneumatic motor, dust extraction must be allowed
to run through the pneumatic tool when it is at
standstill.
depending on their diameter. Using a sanding
pads of the incorrect size will cause excessive
vibration of the tool.
Only use sanding pads with an undamaged burr
layer.
Sanding pads are available in three degrees of
hardness to suit the type of application:
- Hard: high edge strength, for removing coarse
material from surfaces and for sanding edges.
- Soft: universal for coarse and fi ne sanding, with
elastic structure for even and curved surfaces.
- Super soft: high elasticity, for smooth fi ne sand-
ing of moulded parts, curves, radii. Do not use
on edges.
Assembly - see Fig. 4. Make sure the positive-fi t
supports on the sanding pad (4.1) are fl ush with
the ones on the tool (4.2).
4
7

Starting

Tool settings

Always disconnect the tool from

Speed adjustment

Suction unit

In order to prevent damage to the

Sanding pads

Sanding pads have different weights