Flex FX3171A Manuel De L'utilisateur page 13

TO REMOVE THE GRINDING/CUT-OFF
WHEEL (FIG. 6):
a. Remove the battery pack from the tool.
b. While pressing the spindle lock, loosen the
lock nut by turning it counter-clockwise with
the wrench supplied.
WARNING
a standstill.
WARNING
from the tool, or first allow the wheel to cool
down. It may be hot after prolonged use.
FILTER COVER (FIG. 7)
Using the filter cover will improve the
performance and extend the life of the tool.
a. Remove the battery pack.
b. To attach the filter cover, snap the filter cover
onto the tool's foot.
c. To remove the filter cover, insert a flathead
screwdriver (not supplied) into the notch at
the top of the filter cover and pry the filter
cover away from the tool.
CLEAN THE FILTER COVER
To clean the filter cover, tap it against a hard
surface or blow it clean with compressed air.
WARNING
or glasses with side shields.
INSTALLING THE AUXILIARY HANDLE
The auxiliary handle, used to guide and balance
the tool, can be threaded into the front housing
on either side of the tool, depending on personal
preference and comfort.
a. Turn the tool OFF and remove the battery
pack before performing any assembly.
b. Thread the auxiliary handle into the desired
position and securely tighten it in place.
Press the spindle lock
only when the spindle is at
Use protective gloves
when removing the wheel
To reduce the risk of
injury, wear safety goggles
(FIG. 8)
Fig. 6
Spindle Lock
Fig. 7
Fig. 8
-13-
Wrench
1
2
1
2