Possible Faults; Technical Data - ATIKA GTC 250/18 Notice Originale

Before each fault elimination:
− switch off device
− wait until the cutting thread is stationary.
− remove the battery
− wear protective gloves
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine does not start after switch-
ing on
Machine does not work with full
performance
Machine cuts with interruptions
Device does not cut.
Cutting thread is not followed up.
Cutting time with fully charged bat-
tery too short
Unusual vibrations
Type
No-load speed n
0
Cutting diameter Ø
Cutting thread diameter Ø
Thread follow-up
Thread spool
Weight with rechargeable battery
Hand-arm vibration to EN 1033/DIN 45675
Measuring uncertainty K
Sound power level L (according to regulation 2000/14/EG)
wa
Sound pressure level L (according to regulation 2000/14/EG)
PA
Rechargeable battery
Rated voltage
Capacity
Charging time
Operating time
Charger
Mains voltage / Mains frequency
Charging current
Permissible charging temperature range
Weight
21
P o s s i b l
P o s s i b l
Possible cause
Lithium ion battery run down
Lithium ion battery defective
ON/OFF-switch defective
Internal fault
Lithium ion battery run down
Lithium ion battery defective
ON/OFF switch defective
Internal fault
Cutting thread to short/broken.
Device overloaded as grass too high.
No more thread on the spool.
Cutting thread entangled.
Rechargeable battery is low
Battery service life exhausted
Grass debris between thread spool
and protective hood
T e c h n i c
T e c h n i c
e f a u l t s
e f a u l t s
Remedy
Charge the lithium ion battery
Contact the customer service
Charge the lithium ion battery
Contact the customer service
Contact the customer service
Follow up the cutting thread.
Trim the grass in several passes.
Replace the thread spool.
Recoil the cutting thread.
Charging the rechargeable battery
Replace the rechargeable battery
Remove grass debris
a l D a t a
a l D a t a
automatic thread follow-up
approx. 2.20 kg
a
measured sound power level 90.4 dB (A)
guaranteed sound power level 94 dB (A)
GTC
250/18
10000 min
–1
max. Ø 250
1.6 mm
4.5 m
= 2.79 m/s²
vhw
1.5 m/s²
83 dB (A)
AB 18/01
18 V DC
1.3 Ah
approx. 1 h
approx. 40 min
ALG 18/1500
230V 50 Hz
1.5 A
10 – 40 °C
0.5 kg