Possible Faults - ATIKA HB 60-2 Notice Originale

Maintenance work
Check the machine
Clean the machine
Replace the safety label

Possible faults

Before each fault elimination:
− Stop the engine
Wait until the cutting device does not longer move.
−
Remove the spark plug connector.
−
Wear gloves.
−
Fault
Hedge trimmer does not work. • No fuel supply
Hedge trimmer cuts with
interruptions
Engine is running, cutting
device does not move
Decreasing engine power
Cutting device gets hot
Smoke

In case of further faults or inquiries please contact your local dealer.
26
Before After
each use each use


.
Possible cause
• Fuel old or contaminated
• Fault in the fuel line
• Fuel filter clogged
• Spark plug sooted or defective
• Incorrect electrode gap
•
Spark plug connector not placed on.
• Carburetor soiled, incorrectly adjusted or defective • Contact the customer service.
• Engine flooded
•
Cranking mechanism defective
•
Engine defective.
• Internal fault
• Fuel old or contaminated.
•
Spark plug sooted
•
Carburetor incorrectly adjusted
• Internal fault.
• ON / OFF switch defective.
• Cutting device blocked
• Internal fault.
• Clutch defective
• Incorrect fuel composition
• Incorrect position of the choke lever
•
Air filter contaminated.
• Spark plug sooted
• Incorrect electrode gap
•
Silencer blocked
• Carburetor soiled or incorrectly adjusted
• Missing lubrication → friction
• Not enough play
• Cutting blades are blunt
• Incorrect fuel composition
• Carburetor soiled, incorrectly adjusted or defective • Contact the customer service.
Every Every
8 hours 25 hours
Remedy
• Check the fuel quantity
• Drain the fuel into a container outdoors. Fill
the tank with fresh and clean fuel.
• Check the fuel line for kinks or damages
• Clean/replace the fuel filter
• Clean or replace the spark plug
• Adjust the electrode gap
•
Place on the spark plug connector.
• Screw off, clean and dry the spark plug.
Then pull the cranking rope several times
and reinstall the spark plug.
• Contact the customer service.
• Contact the customer service.
• Contact the customer service.
• Drain the fuel into a container outdoors. Fill
the tank with fresh and clean fuel.
•
Clean or replace the spark plug. Check the
spark plug connector.
• Contact the customer service.
• Contact the customer service.
• Contact the customer service.
• Stop the engine and remove the object
• Contact the customer service
• Contact the customer service
• Fuel according to the operating instructions
• Put the choke lever to
•
Clean/replace the air filter.
• Clean the spark plug
• Adjust the electrode gap
• Contact the customer service.
• Contact the customer service.
• Oil the cutting device
• Adjust the sliding play
• Have the cutting device sharpened
• Fuel according to the operating instructions
Every If required
100 hours / damaged

Each
season

