Storage; Possible Faults - ATIKA GTC 40-305 Notice Originale

When transporting the product in a car put it only in the boot

or on a separate loading area.
You may pull the device apart to save space.

Do not throw the device when loading it. Secure the device

against tipping over and damages.
Check the device for damages if it was subjected to hard
jolts during transport.

For information on "Transport" of the battery and the
charger, please refer to the respective "Operating Instructions".

Storage

Before each storage:
switch off device
−
wait until the cutting device does not
−
longer move
remove battery
−
 Store machines that are not in use in a dry locked place
protected against frost and outside the reach of children
and unauthorized persons.
 Do not rest the device on the guard when storing it to avoid
deformation of the guard.
Before each fault elimination:
switch off device
−
wait until the cutting thread is stationary
−
wear gloves
−
remove the battery
−

After each fault clearance, put into operation and recheck all security installations.
Fault code
Machine does not start after
switching on
Machine does not work with
full performance
Machine cuts with
interruptions
Device does not cut.
(Poor cutting results)
Cutting thread is not followed
up.
Cutting time with fully
charged battery too short
Device shuts off on its own
Unusual vibrations
Operating mode cannot be
selected

In case of further faults or inquiries please contact your local dealer.
22

Possible faults

Possible Cause
 Battery run down
 Battery not correct inserted
 Battery, motor or ON/OFF-switch
defective
 Battery run down
 Battery defective
 ON/OFF switch defective
 Internal fault
 Cutting thread to short/broken.
 Device overloaded as grass too high.
 No more thread on the spool.
 Cutting thread entangled.
 Rechargeable battery is low
 Battery service life exhausted
 Lithium ion batteries too hot (45 °C)
 Battery charge too low
 Grass debris between thread spool and
protective hood
 Economy / normal mode toggle buttons
defective
 Best store the device suspended. An opening for hanging it
up is provided in the housing.
 You can also store the device in a space-saving manner by
loosening the locking nut (7) and pulling the upper and
lower part apart.

Before storage, please observe the following to increase
the service life of the device and to ensure smooth operation:
− Carry out a thorough cleaning and maintenance.

Remove the thread spool to make cleaning it and the
guard easier.
 Check the protective hood for damages during cleaning.
 To keep the cutting thread flexible, it should absorb
moisture before use.
Put cutting threads that were stored for a longer period
or purchased new in water for 1 - 2 days before use so
that they can absorb moisture.
− Check the device for perfect condition to ensure reliable
use.

For information on "Storage" of the battery and the
charger, please refer to the respective "Operating Instructions".
Removal
 Charge the battery
 Insert the lithium-ion battery correctly
 Have the battery, motor or switch checked /
repaired by a licensed electrician or customer
service or replaced by original spare parts.
 Charge the battery
 Contact the customer service
 Contact the customer service
 Contact the customer service
 Follow up the cutting thread.
 Trim the grass in several passes.
 Replace the thread spool.
 Recoil the cutting thread.
 Charging the battery
 Replace the battery
 Allow lithium-ion battery to cool down
 Charge the lithium ion battery
 Remove grass debris
 Contact the customer service