Possible Faults; Technical Data - ATIKA HS 710 / 61 Notice Originale

Possible faults

Fault
Hedge trimmer does not work.
Hedge trimmer cuts
interruptions
Motor is running, knives do not
move
Knives get hot
Motor is humming, knives do not
move

Technical Data

Type
Model designation
Motor output P
1
Mains voltage / Mains frequency
No-load speed n
0
Length of knives
Cutting length
Thickness of blade
Cutting distance
Adjustment of handhold
Hand-arm vibration front according to EN 1033/DIN 45675
Hand-arm vibration rear according to EN 1033/DIN 45675
Sound power level L (according to regulation 2000/14/EC)
wa
Sound pressure level L
PA
Weight
Protection class
Possible cause
• No power
• Power failure
• Extension cable defect
• Safety fuse defect
• Motor or switch defect
with • Cable defect
• Internal failure
• Circuit closer/breaker defect
• Internal failure
• Knives are edgeless
• Knives are defect
• Missing lubrication => friction
• Knives are blocking
(according to regulation 2000/14/EG)
Removal (disconnect power plug)
• Check cable, no longer use defect cable
protection
• Check cable, no longer use defect cable
protection
Check power supply, power outlet, fuse
•
• Replace fuse
• Have motor or switch checked by an
approved electrician or replaced by original
spare parts
• Check cable, no longer use defect cable
protection
• Manufacturer
service respectively must be called
• Manufacturer
service respectively must be called
• Manufacturer
service respectively must be called
• Arrange sharpening of knives
• Exchange knives
• Lubricating of knives
• Remove object
HS 710/71
HS 710/71
710 mm
630 mm
measured sound power level 100,2 dB (A)
guaranteed sound power level 103,2 dB (A)
ca. 4,2 kg
16
or responsible
or responsible
or responsible
HS 710/61
HS 710/61
710 W
230 V~ / 50 Hz
1600 min
–1
610 mm
534 mm
1,8 mm
22 mm
± 90° (180°)
a = < 2,05m/s²
vhw
a = < 3,77m/s²
vhw
87,2 dB (A)
ca. 3,3 kg
II
customer
customer
customer