Introduction; For The Home Owner; Owner Orientation; Installer Responsibilities - Briggs & Stratton 01917 Guide D'installation Et D'utilisation

Introduction

Your Briggs & Stratton Transfer Switch is supplied with this
combined "Installation and Operator's Manual". This is an
important document and should be retained by the owner
after the installation has been completed.
Every effort has been expended to make sure that the
information in this manual is both accurate and current.
However, the manufacturer reserves the right to change, alter
or otherwise improve the system at any time without prior
notice.

For the Home Owner

To help you make informed choices and communicate
effectively with your installation contractor(s),
Read and understand the Owner Orientation Section
of this manual BEFORE contracting or starting your
transfer switch installation.
To arrange for proper installation, contact the store at which
you purchased your Briggs & Stratton Transfer Switch, your
dealer, or your utility power provider.
The Transfer Switch Warranty is VOID
unless the system is installed by a
licensed electrical professional.

Owner Orientation

The illustrations are for typical circumstances and are meant
to familiarize you with the installation options available with
your transfer switch.
Local codes, appearance, and distances are the factors that
must be considered when negotiating with an installation
professional. As the distance from the existing electrical
service increases, compensation in wiring materials must be
allowed for. This is necessary to comply with local codes and
overcome electrical voltage drops.
The factors mentioned above will have a direct effect on the
overall price of your transfer switch installation.
NOTE: Your installer must check local codes AND obtain
permits before installing the system.
• Read and follow the instructions given in this manual.
• Follow a regular schedule in caring for and using your
transfer switch, as specified in the manual.

Installer Responsibilities

• Read and observe the safety rules.
• Read and follow the instructions given in this manual.
• Check federal, state and local codes and authority
having jurisdiction, for questions on installation.
• Ensure generator is not overloaded with selected loads.
If you need more information about the transfer switch, call
(800) 743-4115, between 8:00 AM and 5:00 PM CT.

Equipment Description

These new generation transfer switches are intended to
operate compatible electrical loads of normal residential
installations. The load is connected either to utility power
(normal) or home standby power (generator). The transfer
switch monitors utility and generator voltages and will
automatically connect to the appropriate source of power.
Major components of the transfer switch are 2 pole
contactor switches, control circuit board, fused utility
terminals and interconnecting wiring.
The transfer switch is coil-operated from utility or generator
inputs and contains suitable electrical interlock switches to
eliminate the possibility of connecting the utility service to
the generator output. It has ratings capable of switching
generator power into the residence.
The control module circuit board has active circuits sensing
utility and generator voltages. It creates a signal for the
generator start-up, switch transfer, retransfer when utility is
restored and generator cool down periods. The control board
also contains red and green lights indicating the power
sources available.
5