Replacing The Fuse - STANNOL INDUSTA HF Série Manuel D'utilisation

Temperature display flashing.
● Is soldering iron cord damaged?
Replace soldering iron.
● Is the soldering joint too large?
Use soldering with higher power or try to continue.
You can not set the temperature.
● Is password protection enabled?
Enter the correct password to unlock.
If the password is unknown, contact your supervisor.
Note: If the password is not known, you have to perform a hard reset. please refer to the
service manual.

repLAcINg THe FUSe

1. Unplug the power cord from the back of the docking station.
2. Pull out the fuse cover.
3. Remove the bad fuse.
4. Put a new fuse.
Please be sure to use the same type!
5. Fuse cover fitted.
operATINg INSTrUcTIoNS
39