STANNOL INDUSTA HF Série Manuel D'utilisation page 37

TroUBLeSHooTINg oF SoLDerINg STATIoN
warning: Before starting any maintenance or cleaning work, always pull the plug out of the
socket and allow the soldering iron to cool down. otherwise electric shock or burns may
occur. If the soldering station is not working properly or if any failures occur, please contact the
manufacturer or maintenance service agents for service maintenance to avoid personal harm or
damage to the parts of the soldering station. maintenance and repair work should only be done by
qualified and competent personal. This manual only contains instruction which could be carry out
be the user. For detailed maintenance and repair work, which need components to be disassem-
bled, please refer to the separate available Service manual.
Soldering station is not working, not heating or no display.
● Is the mains cable intact and properly installed?
a. Plug in mains cable correctly.
b. Replace mains cable.
● Fuse blown?
Make sure to find the reason why fuse has blown.
a. Check all cables for damage.
b. Refer to the service manual.
warning: replace a new fuse with the same specification.
Soldering iron is not heating, sensor or heating core displays error.
● Is the soldering iron connected to the station correctly?
● check soldering iron cable and plug for any damage.
r econnect or refer to the service manual.
● refer to service manual.
operATINg INSTrUcTIoNS
37