STANNOL INDUSTA HF Série Manuel D'utilisation page 29

If you try to input a non-valid temperature (e.g. 490°C), setup will return to the hundreds digit and
you have to repeat the procedure.
If you switch off the soldering station within the setup process the temperature will not be stored.
Note: The soldering station can be password protected. If a password has been assigned,
the password has to be entered to change the temperature setting. By default the soldering
station is not password protected (see chapter: password setting).
enabling temperature setting, if soldering station is password protected:
● Switch off soldering station.
+
● Press and hold
and
---
● Press
* button (
● Input first digit of the password using
flashing).
● Input second digit of the password using
flashing).
● Input third digit of the password using
● If password was correct
perature and you have to repeat the procedure.
● Waiting for 4 sec brings you to the temperature setup routine. To setup the temperature pro-
ceed as described in 1. or 2. above.
● After setting up the temperature switch the soldering station off and on again.
● The soldering station is now heating up to the desired temperature, which cannot be changed
by the user.
-
buttons and switch on the station (
will be displayed, first digit is flashing).
+
or
+
+
or
O.R. will be displayed, otherwise the display returns to show the tem-
operATINg INSTrUcTIoNS
C
-
button and press *
-
or button and press
-
button and press *
is flashing in the Display).
button (second digit will be
* button (third digit will be
button.
29