Parameter Setting - STANNOL INDUSTA HF Série Manuel D'utilisation

Operating instructiOns

pArAmeTer SeTTINg

password settings
The original soldering station password: „000", soldering station temperature setting is allowed in
this state, should limit temperature adjustment, you must modify the password.
enter modifying password mode
● Switch off soldering station.
+
● Press and hold
and
Input original password
---
● Press "*" button (
● Input first digit of the password using
flashing).
● Input second digit of the password using
flashing).
● Input third digit of the password using
Input wrong password
● The display will return to show the temperature and you have to repeat the procedure.
Input right password
● If the display shows
● Waiting for about 4 seconds soldering station will return to normal working condition.
30
-
buttons and switch on the station (
will be displayed, first digit is flashing)
+
or
+
+
or
O.R.
which indicates that the entered password is correct
is flashing in the Display).
C
-
button and press
*
-
or button and press
-
button and press
*
button ( second digit will be
* button ( third digit will be
button.