STANNOL INDUSTA HF Série Manuel D'utilisation page 36

Operating instructiOns
SoLDer TIp mAINTeNANce
● Set the temperature to 250°C.
● When the temperature is stable, use a clean sponge or brass wool to clean up the iron tip and
check the condition of the iron tip.
● If the tinned part of the tip contains black oxide, it can be plated with the new tin layer. Use a
special tip cleaner like STANNOL Tippy or a solder wire with a highly activated flux core. Do not
use abrasive materials to clean the tip. This might damage the thin layers of the tip plating.
● Clean with a clean sponge or brass wool and check again.
● Repeat cleaning / plating procedure until solder tip shows no defects.
● If the tip shows deformation or serious corrosion it must be replaced.
eXpLANATIoN oF error coDe
● When a problem occurs within the soldering station, an error code will be displayed. Please
also refer to chapter Troubleshooting.
● Sensors error: If any part of the sensor or sensor circuit fails, then the display shows
the input power of the iron will be cut off.
● Attention when temperature is too low: If the soldering iron temperature is 50°C below the set
temperature, the display is flashing to attract the user's attention.
● Heating core error: If the soldering iron heater cannot input power, the display shows
this indicates the heating core might be damaged.
please check Fault Finding for solution.
36
,
SE
,
H-E