Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Input new password
● While display shows
● Input first digit of the new password using
be flashing).
● Input second digit of the new password using
will be flashing).
● Input third digit of the new password using
● If you input an unchanged password, the soldering station returns to normal operation.
Input new password again (same as above!)
---
●
is displayed, first digit is flashing.
● Input first digit of the new password using
be flashing).
● Input second digit of the new password using
will be flashing).
● Input third digit of the new password using
If you have re-entered a wrong password, you have to repeat from "Input new Password".
password protection activation
● The Soldering station is returning to operation mode. Now you are able to setup the tempera-
ture setting ( see chapter: Temperature setting).
● After setting up the temperature switch the soldering station on and off again. The password
protection is now activated and cannot be changed by the user.
● For changing the temperature refer Temperature setting.
To remove password protection renter "000" as a password.
O.R.
press the
*
key, button (
operATINg INSTrUcTIoNS
---
will be displayed, first digit is flashing).
-
+
or
button and press
-
+
or
button and press
-
+
or
button and press
-
+
or
button and press
-
+
or
button and press
-
+
or
button and press
*
button ( second digit will
*
button ( third digit
*
button.
*
button ( second digit will
button ( third digit
*
*
button.
31
Publicité
Table des Matières
