Electrical Safety - STANNOL INDUSTA HF Série Manuel D'utilisation

eLecTrIcAL SAFeTY

● The device may only be connected to a socket that is correctly installed and grounded.
● Make sure that the power supply corresponds with the connection specifications of the device
before it is connected.
● The tool may only be used within the specified limitations for voltage and power
(see type plate).
● Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug
and not by the cable.
● Always pull the main plug on plug housing not on the cable.
● Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and heat.
● Do not lift the device using the cable or use the cable for purposes other than intended.
● Check the plug and cable before each use.
● If the power cable is damaged immediately disconnect the plug. Never use the device if the
power cable is damaged.
● If the device is not in use make sure the plug is pulled out.
● Make sure that the device is switched off before plugging in the mains cable.
● Make sure that the device is switched off before unplugging it.
● Disconnect the power supply before transporting the device.
operATINg INSTrUcTIoNS
25