STANNOL INDUSTA HF Série Manuel D'utilisation page 33

enter temperature calibration mode
● Press and hold the
● Calibration mode is indicated by a dot right beside the hundreds digit.
● While the hundreds digit flashes, press the
recorded temperature.
● Press
and press the
*
● Press
* and press the
● Press
* to return to normal operation.
If the station is password protected, you have to enter the password first (see chapter:
Temperature setting: Enabling temperature setting, if soldering station is password protected).
cHANgINg SoLDerINg TIpS
caution: This should only be done after switching off the power
and the soldering iron has cooled down!
● Switch of the station off.
● Loosen the lock nut
● Remove the heating element sleeve
● Take off the soldering tip
● Slide the new tip
4
● Slide the sleeve
2
● Fasten the lock nut
1 2
* button, and then press the
-
+
or button to enter tens digit of recorded temperature.
-
+
or button to enter ones digit of recorded temperature.
near the handle.
1
.
2
.
3
on the heating element.
on.
.
1
3 4
operATINg INSTrUcTIoNS
-
+
and buttons.
-
+
or button to enter hundreds digit of your
33