Evolution Rage 4 ADVAN-SAW Manuel D'instruction page 5

not tend to throw it from the vice. Clamp it securely. Angles should be in
an inverted position so that the point of the section is uppermost. The
saw cuts most efficiently if the blade is cutting the thinnest section of the
material (fig. 4).
Maintenance And Troubleshooting
Keep tool and cord clean. Regularly vacuum or blow out the motor unit to
keep its ventilation clear, also check that the machine is well lubricated.
Inspect weekly. Avoid using cleaning products, which include benzene,
trichloroethelene, chloride, and ammonia as these can damage plastic
parts. In case of electrical or mechanical malfunction, immediately switch
off the tool and disconnect the plug.
Brush Inspection And Replacement
Excessive sparking may indicate the presence of dirt in the motor or
worn out carbon brushes. Check for wear after the first 50 hours of use
and then at 10 hours use intervals. Replace when they reach 6mm. The
brush holders are located on the motor housing opposite each other
and unscrew to allow access to the brushes. For all other service and
maintenance, take the machine to an authorised service centre after
typically 60 cutting hours, dependent upon the type of workload it has
endured.
Lubrication
Your machines motor bearings are lubricated at the factory with sufficient
lubricant to last for the lifetime of the unit under normal operating
conditions. Other movable parts can be lubricated with light machine
oil as necessary. It is recommended that the machine be taken to the
nearest SERVICE CENTER or Evolution Power Tools USA, Iowa, if in
the USA, at least once a year for a thorough cleaning and lubrication. All
repairs and servicing made by these centres are fully guaranteed against
defective materials and workmanship.
12 Months Warranty
12 MONTH LIMITED WARRANTY. EVOLUTION POWER TOOLS RESERVES
THE RIGHT TO MAKE IMPROVEMENTS AND MODIFICATIONS TO DESIGN
WITHOUT PRIOR NOTICE.
Evolution Power Tools will, within twelve (12) months from the original date
of purchase, repair or replace any goods found to be defective in materials
or workmanship, provided the product warranty registration card has been
returned to Evolution Power Tools. This warranty is void if the tool being
returned has been used to cut materials beyond the recommendations in
the Instruction Manual or if the saw has been damaged by accident, neglect,
or improper service. This warranty does not apply to machines and / or
components which have been altered, changed, or modified in any way,
or subjected to use beyond recommended capacities and specifications.
Electrical components are subject to respective manufacturers' warranties.
All goods returned defective shall be returned prepaid freight to Evolution
Power Tools. Evolution Power Tools reserves the right to optionally repair
or replace it with the same or equivalent item. There is no warranty
– written or verbal – for saw blades. In no event shall Evolution Power
Tools be liable for loss or damage resulting directly or indirectly from the
use or merchandise or from any other cause. Evolution Power Tools is not
liable for any costs incurred on such goods or consequential damages. No
officer, employee or agent of Evolution Power Tools is authorised to make
oral representations of fitness or to waive any of the foregoing terms of
sale and none shall be binding on Evolution Power Tools.
Questions relating to this limited warranty should be directed to the company's
head office, or call the appropriate Helpline number.
Accessories – Genuine Rage Technology Blades
185mm TCT Multi Purpose Blade
Notice: Fair wear and tear and damage caused by misuse is not
covered under the 12-Month warranty.
5